How to Connect Raspberry Pi with GSM sim900a mini rs232

Question

I have connected Raspberry Pi to GSM sim900a mini with the following details:

• convertor max3232 used
• DB9-2 sim900a connected to DB9-3 max3232
• DB9-3 sim900a connected to DB9-2 max3232
• tx (raspberry) connected to tx (max3232)
• rx (raspberry) connected to rx (max3232)

But there's no respond through miniterm.py as I run the command below:

sudo miniterm.py /dev/ttyAMA0

I don't Know why the transfer (send/transfer) is not working.

Answer 1

I have figured out that I can connect to the Raspberry using the UART interface directly. I was using the rs232.The problem is solved then.

Answer 2

have you set baud rate i think 9600,

I don't have idea about miniterm.py, but try to install minicom.

then minicom -s for setting all configuration

and then save as default and then go on, I set up is fine..

and also have you enabled uart in your pi?? if no follow www.robot-electronics.co.uk/files/rpi_serial_setup.doc.