2 Tweaked formatting.
source | link

For anyone finding this on Google, here's the answer based on what @jaromanda and @dougie commented...   

Photo of Makerspot Pi Prototyping Board

The holes I coloured green are connected to the corresponding holes in the GPIO connector, so to connect to a GPIO pin, you just have to solder to the corresponding green hole. Note: one of the holes on the GPIO connector has a square outline, which signifies Pin 1 on the Pi - this is one of the 3.3V supplies, and is the nearest pin to your memory card slot. Note the generous provision of rails for easy connection of power rails etc.. Make sure you don't connect any input to 5V as this will damage the Pi.

For anyone finding this on Google, here's the answer based on what @jaromanda and @dougie commented...  Photo of Makerspot Pi Prototyping Board

The holes I coloured green are connected to the corresponding holes in the GPIO connector, so to connect to a GPIO pin, you just have to solder to the corresponding green hole. Note: one of the holes on the GPIO connector has a square outline, which signifies Pin 1 on the Pi - this is one of the 3.3V supplies, and is the nearest pin to your memory card slot. Note the generous provision of rails for easy connection of power rails etc.. Make sure you don't connect any input to 5V as this will damage the Pi.

For anyone finding this on Google, here's the answer based on what @jaromanda and @dougie commented... 

Photo of Makerspot Pi Prototyping Board

The holes I coloured green are connected to the corresponding holes in the GPIO connector, so to connect to a GPIO pin, you just have to solder to the corresponding green hole. Note: one of the holes on the GPIO connector has a square outline, which signifies Pin 1 on the Pi - this is one of the 3.3V supplies, and is the nearest pin to your memory card slot. Note the generous provision of rails for easy connection of power rails etc.. Make sure you don't connect any input to 5V as this will damage the Pi.

1
source | link

For anyone finding this on Google, here's the answer based on what @jaromanda and @dougie commented... Photo of Makerspot Pi Prototyping Board

The holes I coloured green are connected to the corresponding holes in the GPIO connector, so to connect to a GPIO pin, you just have to solder to the corresponding green hole. Note: one of the holes on the GPIO connector has a square outline, which signifies Pin 1 on the Pi - this is one of the 3.3V supplies, and is the nearest pin to your memory card slot. Note the generous provision of rails for easy connection of power rails etc.. Make sure you don't connect any input to 5V as this will damage the Pi.