I am new to raspberry pi and I recently decided to get RPi 4B. Anyways, I was doing a small project and when I finished, I pulled the jumper wires from the breadboard and the wire connected the GND and 5.0v touched which caused the RPi to reset. Now, I don't own a monitor nor keyboard nor mouse, so I just use a VNC server on my laptop. When the 2 wires touched the VNC server got disconnected, so i waited for the RPi to boot up but the LED was solid red and the ACT was solid green.
I searched this forum for help but all I found that the polyfuse just needs time to heal, but i just learned that the RPi 4B doesn't have a polyfuse, It only has an OVP diode.
It's been a couple hours and still nothing, I tried reinstalling raspbian and even tried a new SD card, so is it dead?
PS:Sorry for post being so long. I just wanted to give you all the details
Thanks in Advance