I am having difficulties getting my scanner to operate. I am using Raspbian Buster on a raspberry pi 3b+. My scanner is a USB Canon LIDE 110, which is connected to the pi through a powered USB hub.

The issue I am having is that I can't seem to use the scanner without root. If I try

scanimage -L 

it doesn't detect it, but

sudo scanimage -L 


device `genesys:libusb:001:008' is a Canon LiDE 110 flatbed scanner

Likewise if I run xsane, it doesn't detect the scanner, but running it with sudo brings up the GUI and everything proceeds as normal. However the images I save are only accessible to root.

I have added myself to the scanner group, which doesn't seem to have changed anything, and I'm out of ideas.

  • How did you add yourself to the group? Did you log out and in after it? – jake Aug 4 '19 at 19:07
  • The following thread might help. The OP has a mirror problem: his program runs OK non sudo, but does not run sudo: raspberrypi.stackexchange.com/questions/101315/… – tlfong01 Aug 5 '19 at 2:48
  • jake - i added myself to the scanner group by the following command "sudo usermod -a -G scanner pi" have logged out and in several times, as well as rebooted the pi numerous times. Is there another way to do it? – Shaker Aug 10 '19 at 3:03

Check your scanner's "idVendor" and "idProduct" values with a lsusb command. Add a udev rule

ATTRS{idVendor}=="04a9", ATTRS{idProduct}=="1908", MODE="0664", GROUP="scanner", ENV{libsane_matched}="yes"

Reload udev with sudo udevadm control --reload-rules.

Add your userid (I'm assuming you're logging in as pi) to the scanner group sudo groupadd scanner and sudo usermod -a -G scanner pi and you should be able to access the scanner without needing sudo.

Plug your scanner in and it should work. Note: I've not tested this.

  • if you could clarify a few things for me, I would appreciate it; I am a beginner at using linux.How do I add a udev rule? Did I do it properly? this is what I did. I cd to /etc/udev/rules.d/, and then I created a file with the following: , ATTRS[idProduct}=="04a9", ATTRS{idProduct}=="1909", MODE="0664", GROUP="scanner", ENV{libsane_matched}="yes" which i saved as canoscan.rules Then I followed the other steps. Following these steps exactly does not seem to have solved the problem; xsane still cannot find the scanner unless I run it as root. Did I do something incorrectly? – Shaker Aug 10 '19 at 2:53
  • linuxconfig.org/… has more detail than I can fit in a StackOverflow comment – Dougie Aug 10 '19 at 8:51

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.