0

I followed this setup to have to configure the failover except wlan become ppp0. Howto migrate from networking to systemd-networkd with dynamic failover

But, the fail over does not work and when i do a networkctl -> ppp0 off failed. Before the config, the 4G module was working well. networkctl tell me -> routable configuring...

and when i do the cat /proc/net/bonding/bond0 i only see eth0.

Someone can help me to make it work?

Thanks a lot

  • Does Step 2 and Step 3 of the tutorial wörk? Do you get two interfaces eth0 and ppp0 up with different ip addresses? Can you ping -I <ip addr of eth0> 1.1.1.1 and `ping -I <ip addr of ppp0> 1.1.1.1? – Ingo Oct 22 at 16:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.