1

I have a project to make mobile robot with Dynamixel AX-12A as the wheel, so i changes the AX-12A to Wheel Mode with CM-530 and it works well.

I follow the guide from http://www.oppedijk.com/robotics/control-dynamixel-with-raspberrypi

I already check my serial communication (UART) on Raspi using Terminal Minicom with only wiring up GPIO14 and GPIO15 together and it works well

Here is my /boot/config.txt at the end of code:

dtoverlay=pi3-disable-bt
hdmi_force_hotplug=1
enable_uart=1
init_uart_clock=16000000

Here is my /boot/cmdline.txt:

dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p7 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait splash plymouth.ignore-serial-consoles

Here is my Python3 Code:

import serial
import time
import RPi.GPIO as GPIO

GPIO.setmode(GPIO.BCM)
GPIO.setup(18, GPIO.OUT)
GPIO.setwarnings(False)

port = serial.Serial("/dev/ttyAMA0", baudrate=1000000, timeout=3.0)

while True:
    GPIO.output(18, GPIO.HIGH)
    port.write(bytearray.fromhex("FF FF 00 04 03 20 FF D8"))
    time.sleep(0.1)
    GPIO.output(18, GPIO.LOW)
    time.sleep(3)

The problem is dynamixel ax-12a not responding to my hexa which should move with value 255. And there is no error feedback from program.

Btw i'm working this project with VNC through wifi in PC, did this cause problems with the communication?

If someone could help me, i thank you.

*sorry if i have bad english

0

After very long discussion, now i can control the motor, the problem is i sent the wrong instruction packet FF FF 00 04 03 20 FF D8, it should be FF FF 00 05 03 20 FF 00 D8.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.