1

I have a Raspberry Pi 4 in a CanaKit case w/ fan.

I am attempting to install the fanless variant of the Uctronics model U6109 PoE hat, but it covers and uses the gpio pins that I previously had the fan connected to.

The pins do not stick up out of the hat for the ones that it "uses" - at least not past being barely palpable (if I remove heatsinks from the RPI board.)

How do I connect the existing fan while using this fanless PoE hat?

1

The "HAT" appears to have pads which expose the "hidden" pins - just use these!

Install a 6 pin (or 8 pin for extra Gnd) header on the 8 pads on the left of the board.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.