I have the following circuit: enter image description here

I am wondering if this configuration will work if I'm trying to add buttons.

I wanted to set them up as GPIO=GPIO.PUD_DOWN and to have it activate on the rising edge, but I'm open to any change.

  • Links as answers are discouraged in Stack Exchange sites, hence this comment. The GPIOZERO library has all the code needed for handling buttons. Just use the button to ground a GPIO pin. gpiozero.readthedocs.io/en/stable/recipes.html#button
    – Bob Brown
    Mar 27 '20 at 18:25
  • I'll look into it. Thank you!
    – George
    Mar 27 '20 at 18:58
  • none of the switches in the schematic are operational
    – jsotola
    Mar 28 '20 at 0:00
  • @jsotola how so?
    – George
    Mar 28 '20 at 0:02
  • the switches do not connect two parts of the circuit when pressed
    – jsotola
    Mar 28 '20 at 0:04

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.