-1

If I put the cursor over the Wi-Fi icon, it says 'No wireless interface found'.

Also, if I press Wireless & Wired Network Settings, the error saving /etc/dhcpcd.conf notification appears. the error notification

The picture below is the result of command sudo nano /etc/dhcpcd.conf. /etc/dhcpcd.conf

And the picture below is the result of command sudo nano /etc/wpa_supplicant/wpa_supplicant.conf /etc/wpa_supplicant/wpa_supplicant.conf

I don't know what's the problem. I tried all the ways to solve problems similar to mine on the Internet, but I can't solve this issue.

Thanks for reading.

Improve this question
15
  • what is the output of mount | grep ext4
    – Jaromanda X
    Oct 8, 2020 at 5:23
  • 2
    You have obviously modified /etc/dhcpcd.conf which is presumably the cause of your problem. DO NOT paste pictures paste TEXT. NOTE there is ABSOLUTELY no point in trying to obscure private IP addresses.
    – Milliways
    Oct 8, 2020 at 5:42
  • 1
    First execute these commands: sudo systemctl daemon-reload and sudo systemctl restart dhcpcd.service. Then do these commands, edit your question and paste its text output to it: ls -l /etc/dhcpcd.conf and systemctl status dhcpcd.service. Don't use screenshots as images!
    – Ingo
    Oct 8, 2020 at 8:37
  • 1
    @Moon you could just open this question here and sign in and edit the question on the RPi. Just copy (I think it's CTRL + SHIFT + C instead, but someone please correct me if I'm wrong) and paste into here.
    – Unsigned_Arduino
    Oct 8, 2020 at 12:00
  • 1
    @Moon Please don't type it out. It's too much and annoying. Take a picture.
    – Ingo
    Oct 8, 2020 at 16:05

1 Answer 1

Reset to default
0

You have obviously modified /etc/dhcpcd.conf which is presumably the cause of your problem; either the contents are corrupt or the permissions wrong.

As you have not explained what you did or shown the contents or permissions and obscured relevant details it is difficult to make any concrete suggestions.

You should restore /etc/dhcpcd.conf to its default. (It is best practice to ALWAYS make a backup copy of systems files before modifying them.)

If you can not do this, either restore from your backup or do a fresh installation - preferably NOT using NOOBS

NOOBS contains instructions for installation.

Judging from the fragments that are visible, you appear to have attempted to set a Static IP Address. This is not recommended in most cases, but if you want to How to set up Static IP Address explains alternatives and instructions on how to do it properly.

How to set up networking/WiFi is a more general guide to configuring Raspbian networking.

PS It is recommended that when editing system files you use sudoedit rather than sudo nano.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.