38

In order to completely waterproof some basic electronic circuits, I've often used potting epoxy to stop anything getting to the internals.

However, this has mainly been with stuff using PDIP, which is must more robust than the smaller packages the chips on the Pi use.

Can I safely use this approach with the Pi, or will it likely destroy it? Has anyone tried?

  • 6
    Given the number of RPis in existence I highly doubt anyone dared try :D – Tibor Jun 12 '12 at 22:55
  • 4
    raspberrypi.stackexchange.com/questions/105/… answers that there are no ventilation requirements. – Tibor Jun 12 '12 at 22:56
  • 4
    @Tibor if you read the link it says allow 2mm around the components. – Jivings Jun 12 '12 at 23:00
  • 2
    Mea culpa, I didn't. – Tibor Jun 12 '12 at 23:02
  • 2
    What makes you think the BGAs and so on are going to like epoxy any less than DIPs? The only problems I would consider are thermal (what are the properties of potting compound?) and gumming up the connectors. – blueshift Jun 13 '12 at 3:56
15

What I would consider when doing this is the ventilation and heat dissipation.

Although I've already specified in another answer that there are no ventilation requirements for the unit, it is encouraged that at least 2mm be left from the surface of the board and the housing.

I would assume that this precaution is primarily for the GPU, as that is the component that reaches the highest temperatures during high intensity tasks.

  • 7
    Of course if you're worried about the heat from the CPU or GPU, you could attach a heatsink and epoxy up to that. – Graham Wager Jun 13 '12 at 12:08
9

You can do this but I see the following problems you will face: - The connectors on RaPi are not water proof and can not be waterproof in an easy way - You can solve the heat problem by gluing a small heatsink to the CPU, and use an epoxy that has good thermal dissipation characteristics

But this is going to be a VERY difficult task and you may need a lot of units before you'll get this to work properly.

Your best bet is to find a water proof box and then use small cables between the RaPi and the box something similar to this: http://factory.dhgate.com/computer-cases-towers/fanless-waterproof-industrial-single-board-3.5-sbc-car-pc-case-ip67-p39010795.html

2

You can buy small aluminium plates and glue them carefully with a super-conductive glue to the chips. Then you can plug cables to all the connectors and glue the whole device into epoxy. Epoxy itself is dielectric so you should be safe. However, you can still encounter several problems:

  • The heat/cooling and stabilisation of epoxy can damage some parts of the device. The pressure changes in that material can be very high. (This can be solved by covering it in epoxy in several steps, lowering the heat produced and the pressures involved.)

  • The epoxy can get between the cable pins and the plug pins, making them disconnect. (This can be solved by using some super-conductive sprays that exist and that are used in extreme conditions, I would as well invest money into expensive gold-covered cables)

  • If you seek for waterproofness, epoxy might not be the best option, it is hard but fragile and can leak water though the crack. I would go for some sort of rubber, e.g. fluid latex, which should work well and stays slightly elastic. Either way (epoxy/latex) you'll struggle with problems of water leakage along the cables.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.