I bought this case.
Now I've got the upper part off the Pi, but the bottom part isn't that easy to get off the Pi.
Is there anyway to easily remove the case or is the best way just pulling very hard?
Raspberry Pi Stack Exchange is a question and answer site for users and developers of hardware and software for Raspberry Pi. It only takes a minute to sign up.
Sign up to join this communityI bought this case.
Now I've got the upper part off the Pi, but the bottom part isn't that easy to get off the Pi.
Is there anyway to easily remove the case or is the best way just pulling very hard?
I find a small flat-headed screwdriver to be extremely helpful in these situations.
Just find a small crack between the case and the Raspberry Pi, then carefully insert the screwdriver. Use the screwdriver as a fulcrum to lift the Raspberry Pi out of the case (keeping the case stationary). Please be gentle.
I used 2 x spludgers on the HDMI side to get the 2 x lock tabs away from where they lock onto the base and then slowly ease it out of the base with a final lift out on the ethernet/ub side as per Lazloman
Wiggle the board gently to get it off of the mounts. Slide the breadboard away from the power and HDMI slots, gently lift the back by the SD slot, then angle the board up and out pulling the USB and network port and lift out of the case.
Solution discovered by one of my students.
I know this is an old thread, but I ran into this problem as well, and what I did to get it out was:
Use my thumbs to pull the case outward and then have someone else work the case loose from the ethernet/usb side.
Hope this helps someone.