0

I have 2 18650 li-ion cells, each at 3.7v

enter image description here

and this bay with this white connector

enter image description here

I saw on youtube that depending on the length of the cell, we can know whether they have integrated "invisible" BMS inside, in a flat circular pcb of the same diameter as the cell, provided the length of the cell. Mines are 64.8mm tall (but still, I don't know if they have integrated BMS as I can't open them).

I'd like to be able to plug and hide the bay in a plastic case.

Now my issues are that:

  1. I want to know which modules I need to buy in order to make a circuit able to charge the 2cells bay out of a single USB(-C) port.
  2. The bay is here to power a raspberry-pi zero through its GPIO, at 5V +-5% and 2A, because the pi has to:

enter image description here

  • be overwhelmed itself by services spinning in it
  • power an USB device over GPIO
  • power a wifi antenna dongle over GPIO
  • share data with a phone over one of the two micro-USB ports (idk if I can prevent it from charging the phone though (I'd like to just transfer data))
  1. So adding a USB-C port for charging the overall system is what I intend to do, but still I'm curious to know whether I could charge the whole thing through the remaining unpopulated micro-USB port of the pi...
  2. I need a power button to cut the contact between the pi zero and the battery tray when I want to shut off my whole device. Led would be appreciated.

To do so I found this guide :

  1. https://www.youtube.com/watch?v=opYVS0EXZIg that uses this module on the below picture, it has everyting : charge and discharrge, led, powerbutton, BUT can only handle 3.7 battery and not my 6.6 up to 8.4V battery tray.

enter image description here

  1. This https://www.youtube.com/watch?v=7AFbrKi0t_4 also seems to only handle 3.7V
  2. I do found this : https://www.youtube.com/watch?v=CzKiflfyeMk but it requires to solder onto the cells, and I want them to be removable unfortunately
  3. Finally I found a guy that used a USB-C port -> that goes into a buck converter outputing 8.4V -> that goes into a 2S BMS (however I looked at BMS on the market and it start at "2S 3A" so idk how to choose the right one) -> that manages the 2 cell battery tray -> then he didn't power some basic arduino/pi, but I guess I'd have to add another buck converter from 8.4V down to 5V ? (but how do I do if the input tension vary from 6.6 up to 8.4?)

Question :

So I'm a bit lost, what modules should I assemble in between the tray and the pi please? What wires diameter should I pick to get these 2A ?

1

If you have no experience in electronics, the easiest solution is to get a powerbank. There are even powerbanks which accept 18650 cells, such as this one (google "8pcs 18650 powerbank"):

enter image description here

Be careful when you put the cells in it: if you plug a cell which has a substantially different charge level it may get damaged, and plugging a cell with reverse polarity is an easy way to start a fire. You can put up to 8 cells in it, but it will work fine with just two. Put some foam / cardboard paper as a placeholder for unused cells.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.