Raspberry Pi 4 InfraRed remote control configuration

Question

I am trying to set up an IR remote control to setup a play, pause, fastforward and rewind command for kodi.

I followed all the guide explaining here but with few success Gitgub-lirc-pi3

only difference is that in /boot/config.txt I inserted dtoverlay=gpio-ir,gpio_pin=18

I have managed to retrieve some command from one remote control but when I run them they have no effect on RPi. The result of irw is:

0000000000000 00 KEY_VOLUMEUP elegoo

however no volume is turning up.

Perhaps your LIRC library and tutorial are outdated. This Q&A might help: Rpi3 LIRC Library and UART IR Transceiver Setup Problem Asked 1 year, 6 months ago Active 10 months ago Viewed 4k times: raspberrypi.stackexchange.com/questions/103452/…. Cheers. — tlfong01, Apr 6, 2021 at 2:05
Thank you sirs, I have found an answer here: peppe8o.com/setup-raspberry-pi-infrared-remote-from-terminal/… — Alessio_110, Apr 6, 2021 at 8:05

Alessio_110 · Accepted Answer · 2021-04-06 08:11:12Z

0

Found an answer via this website Setup Raspberry PI Infrared Remote from terminal . All credits go to the creator of the page.

answered Apr 6, 2021 at 8:11

Alessio_110

1233 bronze badges

Add a comment |

1 Answer 1