I have been trying to get clean audio from raspberry pi 0w. Tried PWM audio + audio amplifier but the audio is noisy. So bought a cheap usb sound card and added an 3W+3W PAM8403 Amplifier. Now the sound quality is much better.

Now i have a different problem. At volume (alsa) 2% I could not here any sound and at volume 3% its too loud and if I still increase to 5% the volume its distorted. Added 10k resistor between sound card and amplifier as below
enter image description here Now volume got reduced but still high.

How do i get smooth volume control?
Increase the 10k ohm resistor
Add a resistor potential divider between left channel & ground and right channel & ground (resistor values?)

1 Answer 1


The USB sound adapter that you refer to seems for headphones, not for input on amplifiers. Depending a bit on the output circuitry of that sound stick, you could provide a typical headphone load, or a voltage divider, or preferably, both. If the stick provides a current-driven output, then adding additional resistors in series would seem counterproductive.

I would suggest a circuit like this:

enter image description here

(also for the other channel)

You can vary the R1 and R2 a quite bit, but I would start with both at 470 ohm. This gives the USB stick a reasonable load and would divide your output by 2.

  • Different USB card for amplifers! Do they specify it or are they available under different name? Anyways i will try the suggested circuit.
    – kk345
    Apr 23, 2021 at 8:10
  • Sometimes, but not always. Your specified "Boost the signals for Headsets". Some have a "line out" connector for amplifiers. In general, I would always try to get some form of manual. Apr 23, 2021 at 9:29

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.