1

How can Rpi connect to and read the DIY PH-4502C pH Sensor?

2
  • 1
    A couple of years ago I experimented with your pH sensor and found it good. I will try to make a short answer here. Stay tuned. – tlfong01 May 5 at 0:56
  • @Pierre Auger, when I answered the question (Ref 1) two years ago, there was only one user guide in Chinese, so everybody got confused. Then I translated the manual to English and also explained how to connect, calibrate, and convert the results. I already compiled a short conversion table. Perhaps you can do more experiments and compile your own conversion table. Happy experiments. Cheers. – tlfong01 May 5 at 1:23
0

Question

How can Rpi read DIY PH-4502C pH Sensor?


Answer

  1. DIY PH-4502C pH Sensor has an analog output. So you can use a multimeter to read the analog values and use a voltage to pH values table to find the pH value. You can also use Rpi to interface an ADC eg, MCP3008, and convert the ADC results to pH values.

  2. I am summarizing some of my findings below.


1. Setting up summary


4502c module


measure


example reading


conversion table


References

(1) DIY PH-4502C pH Sensor Calibration and ADC using MCP3008, PCF8591, and ADS1115, Asked 2019apr18, Viewed 14k times


Appendices

Appendix A - Experiment Results


pH table


orange


tea


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.