I use a RPi with waterproof DS18B20 temperature probes to measure the temperature of my homebrew. Every time I brew a batch I must sanitize the probe and insert them through the airlock into the brew, and then connect the three wires into my bread board. I've done this so much that the novelty has worn off and this is just frustrating. I am liable to have 4 sets of DS18B20 probes measuring 4 batches of beer. When I disconnect or reconnect one probe, it is easy to knock out another probe.
I am thinking about jumper wires and how easy and stable they are to plug into a breadboard. Would it be possible to plug a wire from the DS18B20 into the female end of a male to female jumper wire, and permanently set it?
Or, what else can be done to minimize my problem?