This post shows how to stream using VLC. It works nice and is simple, but it gives me about a second lag. This post uses GStreamer, and it has 0.3 second lag; I would like less.

Is it possible to use Raspberry Pi graphics chip to speed up the encoding?


With Ubuntu 14.10 and Gstreamer I reach 100 to 116 ms latency with 1280 x 720 @ 60Hz.

Tanks to @Antonvh who puts me on the right way. I reproduce here the solution for latter reference.

To stream from the Pi :

raspivid -t 0 -b 2000000  -fps 60 -w 1280 -h 720 -o - \
  | gst-launch-1.0 -e -vvv fdsrc ! h264parse ! rtph264pay pt=96 config-interval=5 \ 
  ! udpsink host= port=5001

To receive it on your computer with gst-0.10 and send it to a virtual v4l2 device (indeed you need v4l2loopback):

gst-launch -v udpsrc port=5001 ! application/x-rtp, payload=96 ! rtph264depay \ 
! ffdec_h264 ! ffmpegcolorspace ! v4l2sink device=/dev/video1

Then you can open the device /dev/video1 in any software supporting v4l2 capture.

For a gst-1.0 solution (v4l2loopback doesn't work with gst-1.0), I let you see the Antonvh blog post.


I achieved a 200ms lag! The trick: send out less frames from the Pi than you read on the remote side, this makes sure the buffer stays empty.

Here's a picture I took of the RPi filming a stopwatch. It shows the time difference.

This is the recipe I use. First on the laptop (Mac) do this:

nc -l 5001 | mplayer -fps 24 -cache 1024 -

then on the RPI start streaming:

raspivid -t 999999 -w 1280 -h 720 -fps 20 -o - | nc 5001

Make sure to:

  • Install mplayer first. Only the Homebrew method worked for me. The regular download was broken.
  • Change the ip number above to the number of your laptop.
  • This is a clever trick! I wonder if it works for the new UV4L driver too – Piotr Kula Oct 23 '14 at 17:54
  • The issue with this solution is that it introduces a lot of stutter from the playback side. I was wondering if you found a solution to that. – 9a3eedi May 1 at 10:18

I use this video recipe: http://archpi.dabase.com/#sending-and-receiving-pi-camera-video-over-the-network

Have you tried https://github.com/thaytan/gst-rpicamsrc ? That should be slightly more streamlined. Tbh, I can't be bothered to try it.

0.3s lag is pretty darn good.

  • 1
    Thanks for the links! I think I have a less-than-0.3s lag now, I still have to document the solution and measure it precisely. Will post soon. If my measurments prove it's more than 0.3 I wil try the other recipe. – Antonvh Mar 5 '14 at 13:34
  • @Antonvh How's the research/measurements going? Is this answer getting you better results? – RPiAwesomeness Mar 25 '14 at 19:44

protected by goldilocks Jan 13 at 14:16

Thank you for your interest in this question. Because it has attracted low-quality or spam answers that had to be removed, posting an answer now requires 10 reputation on this site (the association bonus does not count).

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.