1

I have a Raspberry Pi 4. I am using the Adafruit VL53L0X Time of Flight Distance Sensor. I have connected a T-Cobbler to a breadboard and attached that to my Raspberry Pi. The sensor is wired correctly according to a video my teacher provided. I installed what my teacher told be to install for the sensor correctly. However, when I try to run code. I get a very long error and when I run "sudo i2cdetect -y 1" no number shows up, it's a blank field. I am very new to this and my teacher is not responding. ANY feedback is appreciated, thanks.

https://photos.app.goo.gl/JbXCDT3Hxr8E6Lkn7 --Wiring https://photos.app.goo.gl/wnShijCAVXEF7az98 --Error Message https://photos.app.goo.gl/gLP3mc6ZVpCgBGSv7 --sudo i2cdetect -y 1 message

Improve this question
4
  • Where is the error message? Where is a photo of the wiring? Where is the code you are using? Don't make us guess.
    – joan
    Feb 25, 2022 at 22:00
  • Sorry, I didn't realize the images were too big to send. These links should work
    – Via Iseppon
    Feb 25, 2022 at 23:48
  • this might help: stackoverflow.com/questions/62757687/…
    – tlfong01
    Feb 26, 2022 at 1:51
  • please add the error message text to your post ... a picture of text cannot be copied and searched on the internet
    – jsotola
    Feb 26, 2022 at 5:03

1 Answer 1

Reset to default
0

The i2cdetect shows that you have not connected the device to the I2C bus.

Check and redo your wiring (I can't see anything obviously wrong but the photo is not detailed enough to see what is connected to what).

Improve this answer
2

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.