2

I am using a raspberry pi v2 camera on a raspberry pi 4 8GB RAM board. I am currently trying to connect to a project on edge impulse I built but when I try to connect the terminal says that no camera is detected.

output from the terminal:

pi@raspberrypi:~ $ edge-impulse-linux
Edge Impulse Linux client v1.3.5

[SER] Using microphone hw:1,0
Failed to initialize linux tool Error: Cannot find any webcams, run this command with --disable-camera to skip selection
    at /usr/lib/node_modules/edge-impulse-linux/build/cli/linux/linux.js:435:23
    at processTicksAndRejections (internal/process/task_queues.js:97:5)
pi@raspberrypi:~ $ 

I have gone through several tutorials but none of them worked. any ideas?

1 Answer 1

1

try to do one of the following options:

if you have installed Raspbian with GUI:

  • start up your Raspberry Pi.
  • go to the main menu and open the Raspberry Pi Configuration tool;
  • select the Interfaces tab and ensure that the camera is enabled;
  • reboot your Raspberry Pi.

OR

using the command line in terminal:

  • type sudo raspi-config;
  • use the cursor keys to select and open Interfacing Options;
  • select Camera and follow the prompt to enable the camera;
  • reboot your Raspberry Pi.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.