0

I am starting my first Raspberry Pi project and want to start with controlling some LEDs. I bought a Joy-IT ProtoShield+ (https://joy-it.net/en/products/RB-Proto+) for prototyping but I do not understand it's wiring and the only documentation I found is this image: Joy-IT ProtoShield+

As the LEDs are connected via a wire, I would like to connect them via the screw connections. Furthermore I would like to solder the resistor onto the breadboard.

So I would like to make a connection from one of the GPIO pins to the breadboard, insert a resistor into the circuit and then connect to a screw connection. Can you help me with that?

2
  • the only documentation I found is this image ... look at your board ... it has documentation printed on it
    – jsotola
    Jun 5, 2022 at 19:48
  • May I suggest that you use a wireless breadboard while you're still experimenting.
    – NomadMaker
    Jun 6, 2022 at 0:23

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.