I finally managed to make wlan0 (an Edimax EW-7811Un USB WiFi dongle) connect to my router, but after an
apt-get update I discovered that my Raspberry can't connect outside the local network. The Raspberry is running on the latest (as of writing this) Raspbian image.
- wlan0 is connected to my router and has been given an IP address
- I can ping my router, my printer, and other machines inside the local network, but I can't ping anything in the outside net (also loopback ping on localhost says "host unreachable", but I'd say that it is NAT cancelling 127.0.0.1 requests)
- I can successfully connect through
eth0, but I need to connect through
pi@MinoPi ~ $ ifconfig wlan0 wlan0 Link encap:Ethernet HWaddr *macaddresshere* inet addr:192.168.1.9 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:552 errors:0 dropped:6 overruns:0 frame:0 TX packets:289 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:375003 (366.2 KiB) TX bytes:318051 (310.5 KiB)
pi@MinoPi ~ $ iwconfig wlan0 wlan0 IEEE 802.11bg ESSID:"Sanctuary" Nickname:"<WIFI@REALTEK>" Mode:Managed Frequency:2.437 GHz Access Point: *macaddresshere* Bit Rate:54 Mb/s Sensitivity:0/0 Retry:off RTS thr:off Fragment thr:off Power Management:off Link Quality=100/100 Signal level=100/100 Noise level=0/100 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
auto lo iface lo inet loopback iface eth0 inet dhcp iface wlan0 inet static address 192.168.1.9 netmask 255.255.255.0 gateway 192.168.1.1 wpa-ssid "Sanctuary" wpa-psk "somePasswordHere"