0

I have a Quark elec AIS receiver connected to my raspberry pi 4 and after some randon amount of time it disconnects en reconnects. After this the device number and the ttyACM* number changes. See the log of dmesg below:

[81474.515734] usb 1-1.2: USB disconnect, device number 3
[81474.757311] usb 1-1.2: new full-speed USB device number 4 using xhci_hcd
[81474.871135] usb 1-1.2: New USB device found, idVendor=0483, idProduct=5785, bcdDevice= 2.00
[81474.871150] usb 1-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[81474.871156] usb 1-1.2: Product: USB Composity
[81474.871161] usb 1-1.2: Manufacturer: GD32
[81474.871165] usb 1-1.2: SerialNumber: 200000022405
[81474.879037] cdc_acm 1-1.2:1.0: ttyACM1: USB ACM device

After this AIS dispatcher stops receiving data because its connected to ttyACM0 but this doesn't exist. My question is: Is there a way to force this device to a port so even on a reconnect it stays on this port.

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.