4

I tried to install mjpg-streamer(experimental) in pi. But I don't know what to do after the following command. This remains a lot of time. If I tried to kill it shows errors for next command.

pi@raspberrypi ~/mjpg-streamer/mjpg-streamer-experimental $ ./mjpg_streamer -o "output_http.so -w ./www"
MJPG Streamer Version: svn rev: 
 o: www-folder-path...: ./www/
 o: HTTP TCP port.....: 8080
 o: username:password.: disabled
 o: commands..........: enabled

What can I do next?

2
  • 1
    Wohoo! Welldone
    – Piotr Kula
    Sep 20, 2012 at 11:52
  • 1
    How did you successfully build it? I always run into a Segmentation fault when I run make
    – tzippy
    Jan 15, 2013 at 14:06

1 Answer 1

3

Those messages are good news, it means it is working and waiting for a connection on port 8080. Use your browser on any other machine, go to the IP address op the Raspberry Pi like this:

http://<ip-address-of-pi>:8080

and you should be presented with a page where you can switch to streaming video, or snapshots.

3
  • Hi, it is not working. I got message from vlc media player as :-Your input can't be opened: VLC is unable to open the MRL '192.168.1.30:8080/?action=stream'.
    – sumith
    Oct 8, 2012 at 7:55
  • Yes,mjpg-streamer is working with another camera.Logitech hd720p and shows bad images for e-con ecam -32 web cam.Ref: tanzilli.com/video_streaming
    – sumith
    Oct 8, 2012 at 11:15
  • Thank you,it is working with econ ecam 32 .I just replaced its votage regulator,with Ti's pjrq 3.3 voltage regulator. Thank you very much for your support
    – sumith
    Oct 25, 2012 at 14:50

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.