0

I've purchased these two display modules, however, I am lacking the right connectors so that I can connect to my breadboard and to Pi.

I would like to know what hardware I should purchase for this interface.

LCD display module

OLED Display module

1 Answer 1

3

If it is a 0.5mm pitch cable you could use this flex cable breakout board.

If it is not 0.5mm pitch they have a multi-pitch breakout board

2
  • How to connect the pitch cable with the board? Is a sticky tape sufficient?
    – sebix
    Jul 22, 2015 at 18:02
  • I believe it is designed for you to solder on an Surface mount flex cable connector or solder the flex cable directly to the breakout. It might be possible to use Z-Axis Conductive Tape to connect it.
    – Craig
    Jul 23, 2015 at 15:45

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.