4

I'm using an edimax ew-7811un and I can connect to my 2.4Ghz access point however I can't seem to see my 5Ghz N-class access point. I was wondering if I needed to configure the pi to enable 5Ghz bandwidth?

My router is dual band and broadcasts 2 SSIDs (networkname-2G and networkname-5G), I also have my nexus 5 connected to the 5G SSID and working fine.

Output from running iwconfig:

IEEE 802.11bg ESSID:"SOMESSID-2G" Nickname:"" Mode:Managed
Frequency:2.412 GHz Access Point: someid
Bit Rate:54 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off Power Management:off Link Quality=100/100 Signal level=100/100 Noise level=0/100 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0

Thanks,

Andy

5

The Edimax EW-7811UN does not work in 5GHz networks, it is only caable for 2.4GHz (see http://www.cnet.com/products/edimax-ew-7811un-network-adapter/specs/).

  • Ah, indeed! I got caught out by the 802.11n protocol rather than looking at the bandwidth – Garbit Apr 7 '15 at 12:19
  • Please set then your issue as solved by this answer. Thanks! – bigbang Apr 8 '15 at 6:59

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.