1

After using the same code for over a year, I made some changes to my code a month ago, and now it appears that one of my DS18B20 temperature probes is broken.

My program reads anywhere from 2 to 4 probes at a given time. I can plug three different probes into my breadboard and see them all in cat ls /sys/bus/w1/devices/.

However, after plugging in the malfunctioning probe, it a) never shows up under the previous command; and b) causes the previous command to list any of the other probes.

Would there be anyway to break a DS18B20 temperature probe via software? Perhaps by reading from it too quickly for too long of a time period?

Improve this question
1
  • The short answer is no you can't permanently kill the device via software. That doesn't mean tho that the device isn't bad for some other reason. Also you mention breadboard, those connections are very breakable check them twice and/or move new holes never before used etc etc
    – Tyson
    Dec 21, 2014 at 16:02

1 Answer 1

Reset to default
2

You can not damage the chip this way unless there were other issues (over voltage, static, etc).

I would try to swap two chips to see for possible connection issue.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.