I have 2 Raspberry Pis in my system. One can be 'docked' to the other one and some time later it can become 'undocked'. While docked, the 2 Pis will have a connection between 2 GPIO pins ( 1 pin on each Pi ). So there will be 1 wire that connects both Pis. These 2 Pis will be the only systems on the 'bus', it is only a point to point connection.

I am aware of the Dallas 1-wire protocol ( have used it with a temp sensor on the Pi but it had a kernel driver that did all of the work ), but I know it is difficult to meet timing and there is no easy way to use it from Userspace. I have heard of making a UART at 115200 Baud emulate the protocol but I have no free UARTs in my system. So Dallas 1-wire is not feasible.

Basically, when the 2 Pi's are docked, the master will send the slave an SSID string and there will be a simple ping-like operation ( ping from slave / ACK from slave ) that will notify both Pis they are docked. So the communication is very simple.

This can be completely proprietary with emphasis on simplicity. I can use Python or C or Qt ( C++ ), or just Bash if possible...

I would greatly appreciate any help or guidance on how to achieve this. What is the best, very simple way to implement this communication?

  • did you ever solve this?
    – x29a
    Commented Apr 3, 2016 at 16:50

1 Answer 1


This post contains some discussion on 'bit banging' (apparently the term for software-implemented UART) on a Raspberry Pi - it might have some information you could use ?

How to get more than one uart interface

And as far as simple encoding - the Manchester Encoding scheme looks quite straightforward to implement; but as you have two-way communication, it seems you are going to have invent a protocol which allows two-way operation, so you'll need to add this feature to your protocol. Also - I have no idea how you accurate you need to generate your timings to be for this to work.....I guess you will have to implement in 'C' to get the speed /accuracy you need: perhaps a custom Kernel Module - dunno.

Will both Pis have an accurate date/time set at the point when they are connected ? Maybe you could use that somehow to synchronize (if you are willing to transmit/recieve at a very low data-rate ....(I suspect the 'docked' system will not have got it's time at this point though - I guess it is not connected over IP, and this part of the reason you are doing this...)

Additionally: if you do get this working - could be a nice little project to share to the community - could be a handy way to boot-up a Model-A device by getting a 'leg-up' from another already running/connected Raspberry...

  • bitbangin on Raspbian doesn't work well.
    – Piotr Kula
    Commented Mar 1, 2015 at 21:59
  • I will share when I get it to work. Thanks for the input.
    – PhilBot
    Commented Mar 3, 2015 at 2:45

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.