1

I have several DS18B20 sensors wired to my Raspberry Pi and wrote a python script to read them all. I've had the script running for months without a problem. Last week I performed an update and an upgrade while my script was running and the pi crashed. The SD card was corrupted and I had to build a new one and now I do not see any of the devices at /sys/bus/w1/devices. When I type ls i get nothing, not even the w1_bus_master1

I have a Raspberry Pi Model B, Revision 2.0, RAM 512 MB, Maker Sony. I am running Linux raspberrypi 3.18.7+ #755 PREEMPT Thu Feb 12 17:14:31 GMT 2015 armv6l GNU/Linux. I double checked my wiring to make sure that there are no shorts or opens. I even got a new sensor and wired it to the pi by itself with same result. Could I have fouled something up while performing the update & upgrade while the script was running? Is there a way to test the GPIO port?

2

It sounds like that you have upgraded to firmware which uses device tree. If you were not using device tree before see Firmware 3.18.x breaks I²C, SPI, audio, lirc, 1-wire (e.g. /dev/i2c-1, No such file or directory)

See http://elinux.org/R-Pi_Troubleshooting#GPIO for my method of testing the gpios.

With nothing CONNECTED to the gpios it tests that they can be read, written, and that the internal pull-ups and pull-downs are functional.

0

It appears that the Firmware 3.18.x includes a configuration change to enable Device Tree support by default which caused my problem. Take a look at the read me file here /boot/overlays/readme. Rather than post the entire file here, here's a link.

I added device_tree= in the /boot/config.txt file as noted in the above link since I was unable to read the w1-gpio-overlay.dtb file as mentioned on line 207 of the readme file as that file appears to be a binary file.

  • Adding device_tree= will only be temporary reprieve. At some stage device tree will be compulsory. I'm surprised the answer I gave did not work for you. – joan Mar 14 '15 at 10:03
  • Thanks. I did try the recommend fix but I couldn't figure out how to read the overlays binary file. Perhaps I'll post a new question to see if anyone knows how to the file. – Diane Mar 15 '15 at 21:10
  • You shouldn't need to touch any binary files. You just add dtoverlay=w1-gpio-pullup,gpiopin=4 to /boot/config.txt. – joan Mar 15 '15 at 21:13
  • Thanks, I just changed it and it works. Wish I had voting privileges for you. – Diane Mar 15 '15 at 21:20

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.