1

I was compiling OpenCV for the first time on a Raspberry Pi 2 today. This process takes about 2.5 hours and continuously pushes the RPi to the processing limits it's capable of. About 30-40 minutes in, the Pi started beeping. I picked it up and found it was very warm to the touch even through the case it's in, and had even noticeably heated the ESD mat it was sitting on through the case it was in.

I don't recall the exact beep sequence, but as best as I can remember the Pi beeped once, then beeped once again about 20 seconds (approximate) later, then in about another 20 seconds it beeped twice. By that time I had put it on a perch (I used the small box from SparkFun it arrived in) and I pointed a fan towards it. The beeping stopped and within a few minutes after this rearrangement the Pi was barely warm to the touch through the case, if at all.

I did not have any speakers plugged in at the time so I'm certain the beeps came from a part on the RPi board itself, which part I have no idea.

The case I'm using is this one:

https://www.sparkfun.com/products/13103

which as far as I can tell is the same as this one:

http://www.amazon.com/Premium-Clear-Case-Raspberry-Model/dp/B00MQLB1N6/ref=sr_1_2?s=electronics&ie=UTF8&qid=1441483640&sr=1-2&keywords=raspberry+pi+case&pebp=1441483643877&perid=14K18KXYFNQ67X04AF29

This seems to be the most common case out there at the moment so I would suppose many other RPi users have the same case.

So here are my questions:

1) Has anybody else experienced anything similar?

2) Is there a document somewhere that defines what the beeps (i.e. one beep vs two beeps, beep sequences, etc.) mean specifically? I looked on the raspberrypi.org site and surprisingly could not find such a document. The FAQ section makes a quick mention of temperatures but does not really provide anything concrete and does not mention beep sequences at all.

I suppose I could point a fan at the Pi anytime I'm compiling OpenCV and simply hope this behavior does not occur under any other use cases. I'm curious if anybody has any similar experiences or additional info on this . . .

  • 3
    The Pi has no speaker of any sort. The beeps were not produced by the Pi. – joan Sep 5 '15 at 23:04
  • Perhaps you have a bad inductor. That could make a tiny but audible sound when the cpu is heavily loaded. – John La Rooy Sep 8 '15 at 1:11
1

The Pi does not have a speaker so it can't produce beeps. Either you are hearing things, or one of the components on the PCB is whining/screeching and you may want to replace your Pi.

If you are concerned about overheating and want an extreme solution, take a look at this video

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.