1

I plugged in an Edimax N150 adapter. (I was using "Jessie"). In the upper right hand corner, there was a applet with two computers next to each other. I assumed that was the network symbol, but when I clicked on it, it said "No wireless interface found" and something like, "wlan not associated". I ran a few commands in the terminal and it showed that the kernel (Driver or something) was loaded for it, it could detected by the raspberry Pi. I messed around with "sudo nano /etc/network/interfaces" and "sudo nano /etc/wpa_supplicant/wpa_supplicant.conf" according to some instructions on websites that I found while google-ing, but when I type "sudo ifup wlan0" it states that it couldn't start. Do I need to install some drivers or something? And, what happened to "wpa_gui"?(wpa_gui returns command not found). Should I try Wheezy instead of Jessie? I am using a raspberry Pi 2. Please help.

4
  • Duplicate of raspberrypi.stackexchange.com/questions/39021/…
    – joan
    Dec 6, 2015 at 14:39
  • Yea, that was me too, but that time I had forgotten my email password and posted as a guest. I didn't how to comment as a guest so I logged in and posted a new question, ALSO, the answer ("rfkill" command) didn't work. The command wasn't recognized.
    – John
    Dec 6, 2015 at 14:44
  • 'ran a few commands' doesn't say anything. What commands did you run and what is/was the (relevant part of the) output? Also what's the USB ID of your device? Run lsusb to find out, it's in the format of xxxx:xxxx Dec 6, 2015 at 15:45
  • relevant? raspberrypi.stackexchange.com/a/38434/31077.
    – tejas
    Dec 6, 2015 at 15:55

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.