I want to know how to integrate 6 pin connector to Raspberry Pi 2 Model B. Since the ends are male, So I'll be using female-to-female connector to connect with GPIO.
-
What is this component ? – ahmetertem Apr 8 '16 at 5:19
-
Can you give link of product ? I searched a little bit but didn't see any datasheet – ahmetertem Apr 9 '16 at 5:59
I'm answering over some internet researches.
Your product is replica of this product (I guess). You need to use jumper cables to connect it and wire connection is
- Red = VCC
- Black = GND
- Yellow = TXD
- White = RXD
- Blue = BL (backlight)
- Green = RST
Probably your product will beep after successfully connection too like referenced product.
Try other product's datasheets for further references
According to my product with 6 pins too, I have following configuration, connecting it to an UART USB adapter. Seems that only 4 pins are needed, TD/RD/GND/Vin(5V)
- Vin is not working in 3V on my part so 5v is needed
Comming from this store