I want to know how to integrate 6 pin connector to Raspberry Pi 2 Model B. Since the ends are male, So I'll be using female-to-female connector to connect with GPIO.
I'm answering over some internet researches.
Your product is replica of this product (I guess). You need to use jumper cables to connect it and wire connection is
- Red = VCC
- Black = GND
- Yellow = TXD
- White = RXD
- Blue = BL (backlight)
- Green = RST
Probably your product will beep after successfully connection too like referenced product.
Try other product's datasheets for further references
According to my product with 6 pins too, I have following configuration, connecting it to an UART USB adapter. Seems that only 4 pins are needed, TD/RD/GND/Vin(5V)
- Vin is not working in 3V on my part so 5v is needed
Comming from this store