1

I have RPI-3b and Sunfounder kit 1.0, and 40 pin GPIO extension board and cable.

Is it possible to use these device and components together?

PS: Sunfounder kit 1.0 is for RPI 1,2(b+).

  • I believe the GPIO layout of the Pi 3, Pi 2 and B+ is the same, so in that sense it should work. – Darth Vader Jun 6 '16 at 10:48
  • I tried project from the URI: sunfounder.com/learn/category/… and it did not work.I just changed the GPIO pin numbers in C code. I through it might be compatibility issue. – Anhbayar Otgonbayar Jun 7 '16 at 8:17
  • Could you try the project with the GPIO pin numbers left as they were? – Darth Vader Jun 7 '16 at 8:29
  • Actually the project code was for 26 pin GPIO extension. There was a difference between pin numbers. I could not find 0 and 1 GPIO numbers from 40 pin GPIO extension board. That was the problem. – Anhbayar Otgonbayar Jun 7 '16 at 8:39
  • I am sure there has to be some sort of conversion chart between the 26 pin GPIO and the 40 pin GPIO layout. – Darth Vader Jun 7 '16 at 9:02
1

The Pi3B will operate in exactly the same manner as a Pi2B, Pi B+, Pi A+, and Pi Zero when used with the Sunfounder kit.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.