I am running the below lines to try to load my two therms.
sudo modprobe w1-gpio
sudo modprobe w1-therm
ls /sys/bus/w1/devices
All I am getting is 00- instead of 28-
I have checked wiring, works fine. It has been working for months but had to replace SD card due to failure.
I've also added to /boot/config.txt
- dtoverlay=w1-gpio
Power is hooked to 3.3, data is to GPIO 4.
Everything is up to date.
/boot/config.txt
and reboot. If that doesn't work add the output ofuname -a
to your question. – joan Jun 19 '16 at 6:56