1

i just started using lirc on raspberry 3. with

sudo apt-get install lirc 

i put on the rpi, i changed the entries in

modules
hardware.conf
config.txt

as stated in http://alexba.in/blog/2013/01/06/setting-up-lirc-on-the-raspberrypi/

but i dont get any in- and out-pins associated with lirc. these are my outputs:

uname -a

Linux raspberrypi 4.4.16-v7+ #899 SMP Thu Jul 28 12:40:33 BST 2016 armv7l GNU/Linux

cat /sys/kernel/debug/gpio

GPIOs 0-53, platform/3f200000.gpio, pinctrl-bcm2835:

GPIOs 100-101, platform/soc:virtgpio, brcmvirt-gpio, can sleep:
gpio-100 (                    |?                   ) out hi    

sudo dmesg | grep lirc

[3.662057] lirc_dev: IR Remote Control driver registered, major 245 
[4.659023] lirc_rpi: module is from the staging directory, the quality is unknown, you have been warned.
[5.618718] lirc_rpi: auto-detected active high receiver on GPIO pin 18
[5.619407] lirc_rpi lirc_rpi: lirc_dev: driver lirc_rpi registered at minor = 0
[5.619411] lirc_rpi: driver registered!
  • i thought, the standard config would do me in and out on GPIO17 and 18. instead of it i've got only a virtual pin.
  • possible hint: i use a python-script on startup with GPIO-Usage (physical Buttons) - disabled on startup for now.
  • how to get "real" connections for lirc?
  • I don't know anything about lirc but I do know that using 3 year old tutorials written for an obsolete OS which predates systemd and Device Tree isn't going to work. Try some more research based on current OS. – Milliways Aug 15 '16 at 11:41
1

Ignore all those outdated instructions and UNDO any changes you made.

Add the following to /boot/config.txt and reboot.

dtoverlay=lirc-rpi,gpio_out_pin=17,gpio_in_pin=18

For general device tree help see /boot/overlays/README.

In future make sure you are using an up to date tutorial as things change quite quickly on the Pi.

  • thanks for the advice. but it didnt changed anything. only this one virtual lirc-connection on gpio-100. raspberrypi.stackexchange.com/questions/50873/… i tested these informations as well - and theyre not that far from old blog-entries. – chmee Aug 15 '16 at 13:15
  • As long as you have done what was suggested then LIRC should work. Time to double check your hardware and wiring. Perhaps add a photo to your question. – joan Aug 15 '16 at 15:03
  • after testing the lirc-input (although it wasnt listed in cat /sys/kernel/debug/gpio, that was my main question above) -> it works, maybe it worked before (i only tested the output-gpio) – chmee Aug 15 '16 at 22:49

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.