0

Which GPIO pins does the 2.4 inch Adafruit monitor use on the Pi Zero?

I am an amateur at soldering so I would only like to solder the minimum amount of pins in order to minimize the risk of messing it up. So, I would like to know which pins are used by the monitor for general purpose use.

Here is the GPIO layout: enter image description here

please could you show me which ones are used?

|improve this question
0

Per Adafruit's documentation for the screen:

This design uses the hardware SPI pins (SCK, MOSI, MISO, CE0, CE1) as well as GPIO #25 and #24. All other GPIO are unused.

The Zero shares the same 40-pin GPIO arrangement as other Pis - you can figure out which pins are which at the extremely helpful pinout.xyz.

|improve this answer
  • Ok, but I assume it uses the power pins too, and a ground pin, in that case which one? – PiNewbie Jan 30 '17 at 18:28

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.