I'm owning a Rasperry Pi3

I want to disable automatic boot when plug in power cable. I don't want to use a simple mechanic switch because I want passive power still avaible for the board for various reasons.

I couldn't find a solution. I wouldnt' have had any problems soldering stuff because I already added a power button for shut down/restart the pi

  • The Pi boots when power is applied. If you don't like that behaviour you have bought the wrong device. – joan Feb 6 '17 at 14:15
  • 1
    Sorry but that is what I already know. You don't tell me "There is no power button, you have bought the wrong device" when there is a solution avaible for this (soldering pins on the board). And that is why I ask this question for my specific problem. ANd maybe there is a solution for this – RaspPiNovice Feb 6 '17 at 14:18

You can connect to two pins of the RUN header to keep the Pi3 in reset and thus not booting.

See here where this connector is:

The two pin "run/reset" header seems to have moved [..] to the other side of the 40 Pin GPIO connector between that and the outermost Pair of Stacked USB connectors

Function of the RUN pin explained for the Pi2 here. I reasonably expect the same behaviour for the Pi3.

It is also unlikely to damage the Pi by keeping it in reset indefinitely, see here.

| improve this answer | |

I have seen a hardware solution: http://www.linuxjournal.com/content/switch-your-rpi

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.