What I have:
I would like to make this thing portable and would like to add a rechargeable battery.
In the case, there is a small open space that I could add a battery. The space is about 3 x 0.5 x 1 in (8 x 1 x 2.5 cm) so the battery would need to fit that space.
The second part of this is that it needs to be able to provide enough power to power both the pi and the screen (and also anything on the pins or in the usb). The website for the screen says 2Amps, but I don't know how amps, volts, watts, ... work so I don't know what is needed or how this would work.
Also, I would like it to have a long battery life. (Min 2 hr, but if I can reasonably get a much longer use out of it on a full charge, then that is even better).
I was thinking about either using one of those power chargers used to charge your cell phone while on the go or I have seen these Lithium ion polymer batteries online that might work, bit again, I don't know which one to get.
Lastly, in order to keep it all within the case, I was thinking about plugging the battery into the large USB port found on the adapter board that came with the screen: but it says
PWR OUT which makes me think it might not work. Another option I think might work is to split the wires on the battery and connect it to the pins on both the pi and the adapter board. Any ideas on if this could work or, if not, another work around?
Either way, I would need to able to charge the battery using the micro usb port on the card or pi.