1

I have a MEMS Digital Microphone with PDM output. I am planning to use this:

http://www.st.com/content/ccc/resource/technical/document/datasheet/57/af/88/31/7b/59/4f/77/DM00111225.pdf/files/DM00111225.pdf/jcr:content/translations/en.DM00111225.pdf

Based on my research, PDM output signals have high-frequency ranges; usually in MHz. To be further processed, it must be filtered/decimated with the use of CODEC. I am planning to use the WM8731.

Based on the datasheet of the digital microphone, typical connection is as follows:

enter image description here

However, I do not exactly know as to what exact pins do the Digital output of the mic to be connected, and also the clock signal. Can anyone help me out with this?

Also, I understand that the Raspberry Pi Zero W can communicate with the CODEC via I2S. And to do so, I must utilize the SPI pins of the Rpi. However, still same questions arise as to what exact pins on the WM8731 CODEC should I connect the SPI signals to.

Thanks.

1

I was looking to wire something similar, and This post here has a link that show how to wire it Digikey sells that little board from adafruit with the microphone already soldered to it and a handy pin connector, it also provide mic datasheets and adafruit same guide. have a link.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.