0

Sorry if the title is confusing, along with my question below. I might have to break this into multiple questions.

I'm quite new to this.

I am trying to control a cheap RC car with my Pi via my laptop. I have the GPIO correctly wired to the controller inputs and can make the car turn left, right, forward, reverse by turning the pins on and off manually . But I want to do this as I was able to before I rewired the controller only using keyboard inputs.

Someone told me today it may not be possible to do exactly what I am trying to do unless I use Pulse Width Modulation (which I am not too familiar with yet). Also I have seen a similar project that apparently needed a relay module to get it working (can anyone affirm this?)

I want my program to continuously loop and if the forward/reverse, left/right keys are pressed, change the GPIO.ouput's accordingly. Also, if only one or no directional key is pressed, have the GPIO.output's be in their neutral states.

I have read some similar questions including this one Controlling a common RC car

and tried some different approaches but could use a few tips. Money is tight and I don't want to go and buy hardware if I don't have to. Can anyone help provide some direction?

Thank you.

0

Ok, I've got this sorted out. Here is the working code: https://github.com/166inter/raspberryPorsche/blob/master/Autonomous1.2.1.py

It uses threading and a queue that, when empty, returns to the default state (straight steering, no forward or reverse). Else, the next command will be taken from the queue.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.