2


I am trying to build a 3D printer farm with the pi, and I need a large USB hub. I found this hub. But don't know how to evaluate if its any good.

Has anyone tried something like this?
Do you have a 7+ port hub to recommend?

9
  • 1
    Check elinux.org/RPi_VerifiedPeripherals for all known-to-work hubs. If the hub in question has an issues with backfeeding, you could just strip the wire a bit and snip the 5Volt line.
    – Gerben
    Commented Jun 26, 2013 at 15:11
  • @Gerben none of those are cheap because they are branded
    – GuySoft
    Commented Jun 26, 2013 at 19:16
  • You're asking for 2 mutually exclusive things here IMO.
    – Lawrence
    Commented Jun 27, 2013 at 6:37
  • @Lawrence You are saying there is no cheap USB hub without backfeeding? I meanwhile ordered this, because someone said it works in the comments.
    – GuySoft
    Commented Jun 27, 2013 at 6:43
  • 1
    Well, snipping the 5V line will definitely work. That 7port hub is the same as the one that I have, and it backfeeds. I should rephrase what I said earlier, there's no cheap 7port hub that will not backpower without modification. All cheap ones don't have proper power regulation to prevent backfeeding.
    – Lawrence
    Commented Jun 27, 2013 at 8:18

1 Answer 1

3

Raspberry Pi boards manufactured in the third quartile of 2012 do not have issues with backfeeding anymore (due to removed fuse), see http://www.raspberrypi.org/archives/1929 and http://elinux.org/RPi_HardwareHistory#Board_Revision_History.

As previously mentioned you can check http://elinux.org/RPi_VerifiedPeripherals#Powered_USB_Hubs for HUBs, but you should be able to safely power raspberry pi by backfeeding it.

Citing from penguintutor post @ http://www.raspberrypi.org/phpBB3/viewtopic.php?f=26&t=17560

Electrically the only different between the supply from the micro USB and the backfeed supply is that the micro-USB has a 1100mA fuse, whereas the USB ports each have a 140mA fuse. There is a diode preventing the USB power from going into the power out of the USB controller, but not so for the USB supply (which is what makes back feeding possible).

So get yourself some nice USB 1.1/2.0 compatible hub and if it is backfeeding, just roll with it. The only issue I can think of, is that some hubs have dedicated "charging" ports which could actually be only ones designed for >1A load.

2
  • I have both a rev2 and a rev1 PI I can reach. Will test and update you if it works :)
    – GuySoft
    Commented Jul 3, 2013 at 11:37
  • Got backfeeding from a RAMPS 1.4 board on a rev2 and rev1. It works fine on a PC
    – GuySoft
    Commented Jul 20, 2013 at 16:49

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.