Reading multiple channels from a pcf8591 ADC

Question

I am writing a little "oscilloscope" program in c++ using /dev/fbx. I am reading in analog values via a pcf8591 connected to the I2C bus. Every thing works well if I only read 1 channel of analog data. But if I add in a 2nd channel the data gets messed up. There are a lot of extraneous 0 and 255 as well as data from one channel showing in the read from the other channel.

Here is a sample of what I am doing:

... part of an infinite loop ..

    wiringPiI2CWrite(fd, 0x40 );
    sig2 = wiringPiI2CRead(fd) - 100;
    sig2 = wiringPiI2CRead(fd) - 100;

    sig3 = (x & 0xff) / 2;

 commented out---
    wiringPiI2CWrite(fd, 0x43 );
    sig3 = wiringPiI2CRead(fd) - 100;
    sig3 = wiringPiI2CRead(fd) - 100;
commented out--

......................

This code works perfectly with channel 0... But when I uncomment the 3 lines for channel 3 the data gets messed up..

I've tried using the auto-increment function but the same problem. I does not matter what channel I use - only if I use more than 1 channel. I've also tried using long delays after each read and write but to no avail.

Any ideas out there??

Answer 1

Interpreted from the datasheet. Your module may have differences.

Connect Pi 3V3 - VCC, Pi Ground - Ground, Pi SDA - SDA, Pi SCL - SCL.

I2C address 0x48

P4 The thermister voltage is provided at AIN 1.
P5 The photocell voltage is provided at AIN 0.
P6 The single turn 10K ohm trim pot voltage is provided at AIN 3.



7 6 5 4 3 2 1 0
0 X X X 0 X X X
  | | |   | | |
  A B B   C D D

0 1 0 0 0 1 0 0

A 0 D/A inactive
  1 D/A active

B 00 single ended inputs
  01 differential inputs
  10 single ended and differential
  11 two differential inputs

C 0 no auto inc
  1 auto inc

D 00 select channel 0
  01 select channel 1
  10 select channel 2
  11 select channel 3

I give several examples of reading the PCF8591.

Non-pigpio C + Python

pigpio C

pigpio Python