I'm working on Raspberry 2B with Raspbian Strech. I plugged a USB / DVI adaptator which is listed in the lsub command :
pi@raspberrypi:~ $ lsusb
.../...
Bus 001 Device 006: ID 17e9:4301 DisplayLink
..../...
I installed the DispalyLink driver version 4.4.24 from here The last version doesn't work. I've got these library errors :
~# : sudo /opt/displaylink/DisplayLinkManager
./DisplayLinkManager: /lib/arm-linux-gnueabihf/libm.so.6: version `GLIBC_2.27' not found (required by ./DisplayLinkManager)
./DisplayLinkManager: /usr/lib/arm-linux-gnueabihf/libstdc++.so.6: version `GLIBCXX_3.4.25' not found (required by ./DisplayLinkManager)
./DisplayLinkManager: /usr/lib/arm-linux-gnueabihf/libstdc++.so.6: version `CXXABI_1.3.11' not found (required by ./DisplayLinkManager)
./DisplayLinkManager: /lib/arm-linux-gnueabihf/libc.so.6: version `GLIBC_2.25' not found (required by ./DisplayLinkManager)
~# : strings /lib/arm-linux-gnueabihf/libm.so.6 |grep GLIBC
GLIBC_2.4
GLIBC_2.15
GLIBC_2.18
GLIBC_2.23
GLIBC_2.24
GLIBC_PRIVATE
In according this procedure : https://support.displaylink.com/knowledgebase/articles/1883065-using-arm-binaries-on-raspbian-on-raspberry-pi
and using the driver version 4.4.24 I've to use these commands :
xrandr --setprovideroutputsource 1 0
xrandr --listproviders
After theses commands I can see the both monitor in the xrandr list. After that, I can apply xrandr configuration as dual screen but the screen which is connected on the USB device is frozen.
So I apply the lightdm restart : sudo service lightdm restart
Only the monitor which is connected in USB still up and running the other one which is connected on the HDMI is switched off. I've to restart the Raspberry board for get the HDMI port working.