I bought a display via eBay (https://www.ebay.at/itm/3-5-TFT-LCD-Touch-Screen-Module-320-480-RGB-Display-Case-For-Raspberry-Pi/391223449334?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649) to get it to work for my Raspiblitz Pi. The display is already mounted and enlightens, but nothing is shown after installment of the drivers.
Maybe you can help me.
I did the following steps:
I got the drivers from here --> http://en.kedei.net/raspberry/raspberry.html
It's the LCD_show_v6_1_3
1.) So i ssh into the Raspiblitz 2.) Downloading the drivers with sudo wget "http://en.kedei.net/raspberry/v6_1/LCD_show_v6_1_3.tar.gz" 3.) Unpacking tar -xzvf LCD_show_v6_1_3.tar.gz
Following the other steps below. Everything finishes successfully and Pi is rebooting, but after reboot nothing is shown on the display.
Description for installation from the display manufacturer:
b. Using the drive.
Writing your own image files to the SD card, and start the Raspberry Pi Ensure that the network connection is normal The LCD screen and the Raspberry Pi board is properly connected Copy the driver to raspberry pi (using ssh or use U disk medium mounted) Unzip the file and start the installation. First expansion sd card sudo raspi-config select expand_roofts then sudo reboot Restart enter the following command: Unzip the file tar -xzvf LCD_show_v6.tar.gz Jumped into a folder cd LCD_show_v6 To upgrade the system update sudo apt-get update Backup data sudo ./LCD_backup Install the driver sudo ./LCD35_v Wait for some time and the system will install the driver automatically restarts If you want to re-use before installing the system, you can use sudo ./LCD_restore Note: Before you update your system, you must use at the command sudo apt-mark hold raspberrypi-bootloader Then use the following command, sudo apt-get update sudo apt-get upgrade
Otherwise it will fail in the future may restart