Linked Questions

1 vote
2 answers
8k views

Raspberry Pi 3 B insanely slow on basically all tasks

My Raspberry Pi 3 B is only connected via Ethernet to the network and running a couple of server tasks, among them an HTML web server (nginx PostgreSQL Typo3). This was working perfectly fine for ...
kleines Filmröllchen's user avatar
5 votes
1 answer
4k views

Output fsck on boot to a log file

I'd like to use fsck on every boot of my RPi 3B+ server. To do this I will be using tune2fs -c 1 /dev/mmcblk0p2. When fsck runs I'd like the output to be added to a log file in /home/pi/fsck.log with ...
dominic03's user avatar
  • 357
0 votes
1 answer
7k views

OpenELEC: filesystem corruption has been detected (after first reboot)

So I have been trying to install OpenELEC on my brand new RPi3B+ multiple times but everytime I install it, upon the next reboot I get this annoying warning that the file system is corrupted: ...
malat's user avatar
  • 227
1 vote
2 answers
4k views

SD card no longer readable after Raspberry Pi Imager failed

After attempting to add Raspberry Pi OS to my SD card using Raspberry Pi Imager v1.5 on Windows 10, the install abruptly threw an error about a third of the way through writing. Now the SD card ...
calcium3000's user avatar
0 votes
2 answers
2k views

How to determine if hardware is damaged

I have a Pi 3 Model B Rev 1.2 which has been running fine for 2 months. It was accidentally knocked off its shelf yesterday (about 1foot drop) It booted back up fine, but now it only stays on for 20 ...
Ken Ingram's user avatar
1 vote
1 answer
2k views

After I plug in the power, there's just a solid red LED with a single green flash

I've left my Raspberry PI 4 Model B on a shelf for quite a while but now that I finally figured out what I wanted to do with it, I can't get it to work at all. I've used the rpi-imager from my Linux ...
ItsDrike's user avatar
0 votes
2 answers
827 views

How to save session in Raspberry Pi?

I am currently running Raspbian on Raspberry PI 3 and the SD memory card I've been using as hardrive on my pi is somehow got damaged probably from using it for a very long time. Whenever I boot or ...
ThN's user avatar
  • 1,063
2 votes
1 answer
1k views

Raspberry Pi 3 Model B won't boot but SD Card and board are fine

My RPi has worked fine for a while but recently it stopped booting, only the red LED is on while the green ACT one is not. I'm sure board is fine because I put another SD Card from another RPi and it ...
Thomas Ukenagashi's user avatar
1 vote
1 answer
237 views

Disk access seems slow? [closed]

My system seems SLOW. In addition, I've suffered file corruption, both to my FAT32 /boot/ and to the ext3 partition. I haven't a clue why it might be slow as the SD card is a quality Phillips card ...
daneee's user avatar
  • 71
1 vote
1 answer
419 views

Why does updating Raspberry Pi OS keep breaking my system?

For some weird reason, updating Raspberry Pi OS keeps breaking my system. For the second time since setting up my Raspberry Pi 4 (8GB RAM), my microSD card has been corrupted and cannot run the OS. ...
shwin320's user avatar
  • 111
1 vote
2 answers
359 views

Copy my setup from a non-booting SD card to a fresh USB install

Alright, long story short, I've been running a copy of Raspbian Lite for a while on a RPi 4, off a MicroSD card. I'm using it along with a couple of USB3 drives as a makeshift NAS, where I store my ...
ardendolas's user avatar
0 votes
1 answer
123 views

Raspberry Pi 3B+ - Windows 10 IOT - Led Flashes 7 Times

I have a problem with my 3b+ that I am using as an aquarium controller. This controller seems to work fine for multiple days and then it stops updating my web server. Which it is supposed to do via ...
chris crowe's user avatar
0 votes
1 answer
125 views

system won't fully boot - “failed to start dhcpcd on all interfaces” and failed to start openbsd secure shell server

It also says failed to start "enable compressed swap in memory using zram". Any ideas why my system keeps getting corrupted? Sorry - ideally any ideas how I can repair/restore?! Thanks
daneee's user avatar
  • 71