Linked Questions

11
votes
3answers
19k views

Raspberry Pi 3, wifi goes to sleep?

I'm facing a similar issue to this one, How do I disable suspend mode?, except I have a Raspberry Pi 3 and am running OpenELEC 6.0.3. When I leave it on without using it for awhile, I can no longer ...
6
votes
3answers
4k views

Local network between two RPis?

I am purchasing another RPi because my original is broken, but not entirely, so I would like to chain them together via and ethernet cable. Each Pi will also have access to the internet via wifi, but ...
1
vote
3answers
2k views

Connect headless pi to arbitrary WiFi network

Sometimes I have to take my headless system to places that I don't know the WiFi SSID/Password before hand. SSH does not reliably work via usb, which is a pain anyways with my enclosure. Is there a ...
6
votes
2answers
12k views

Can I use eth0 and wlan0 at the same time in diffrent purpose?

I use Raspbian Jessi(kernel v4.4) on Raspberry pi 3. These are my configurations. pi@raspberrypi:~ $ cat /etc/network/interfaces source-directory /etc/network/interfaces.d auto lo iface lo inet ...
0
votes
2answers
219 views

dhcp obtains IP but no connection to Internet after upgrade to Jessie from Wheezy

Device : Raspberry-Pi 2 Model B I upgraded from Wheezy 7.11 to Jessie 8.0 I upgraded using : apt-get update apt-get upgrade apt-get dist-upgrade I am connected to my eth0 (Wired LAN) when I was ...
0
votes
2answers
261 views

Should I expect major differences between Raspbian and Ubuntu?

I'd like to use VirtualBox at first and instead of Raspbian, Ubuntu Mate. Should I expect some differences while setting up a 3G connection?
12
votes
1answer
59k views

RasPi 3 - wlan0 not associated

I have two RasPi3, both on the newest Jessie and updated && upgraded. The problem is that both Pis can see networks but are not connecting to them. sudo iwlist wlan0 scan Gives me multiple ...
4
votes
1answer
477 views

Wireless LAN no longer works since dist-upgrade

I have been using my Raspberry Pi 1 for over a year as a wireless bridge. I purchased a Pi2 and wanted to move the SD card across, but the first thing I had to do was upgrade the distro to support the ...
3
votes
1answer
4k views

Does appending ipv6 to /etc/modules enable IPv6 at boot?

Apparently, I can enable IPv6 in two ways. To test, I first confirm it's not enabled currently. $ ping6 -c 1 ::1 socket: Address family not supported by protocol I then enable it immediately $ sudo ...
3
votes
1answer
13k views

Static IP adddress on Raspbian not using dhcp service at all

I have Raspbian Jessie on RPI 2 B, I cannot set my wired NIC with a static IP address. I have uninstalled raspberrypi-net-mods ifplugd, because have a lot of stability issues and insists on uses ...
1
vote
1answer
150 views

Router not recognising Raspberry Pi 2 B

I'ver never worked with any Raspberry model before and now one of my university courses requires me to. Since I don't have any spare peripheral devices to connect the raspberry to I'm trying to access ...
0
votes
1answer
127 views

How to get sure that the Internet connection has been correctly transfered?

I'm currently working on a project of making an highly secured router with my RaspberryPi to navigate anonymously on the net. Yet, I'm not able to correctly transfer the Internet connection to the new ...
0
votes
1answer
256 views

Pi reject ssh connect after pi idle an hour

i am new to pi, and i use it as webserver. but every time i dc from ssh, after few hour connect again, pi reject my connect, even use vnc or ssh. what i can do is unplug my power to manual reboot. (...
2
votes
0answers
429 views

USB Wi-Pi not connecting to WiFi - 4-Way Handshake

I have a USB Wi-Pi stick which is supposed to enable my Pi to connect to WiFi. I have opened up 'WiFi Configuration' and when trying to connect, the status will show '4-Way Handshake' for about 10 ...
1
vote
0answers
64 views

How do you bridge your wlan0 to your eth0?

I'm trying to bridge the wlan interface of my Pi with the ethernet port. I found this tutorial that shows how to do this on Debian - but I'm unable to get it working. I'm quite a layman on Linux and ...

15 30 50 per page