Linked Questions

78
votes
7answers
142k views

How to automatically reconnect WiFi?

I'm using my pi to monitor my power meters. Data is transferred to PC by WiFi connection using Edimax EW-7811UN USB adapter. When the Wifi connection drops (switched off over night, or shaky ...
12
votes
9answers
17k views

Static IP Failing for wlan0

I am currently trying to set up my Raspberry Pi as an Access Point using hostapd using the following directions: RPI Wireless Hotspot Unfortunately, my static IP Address refuses to set at startup. ...
12
votes
1answer
58k views

RasPi 3 - wlan0 not associated

I have two RasPi3, both on the newest Jessie and updated && upgraded. The problem is that both Pis can see networks but are not connecting to them. sudo iwlist wlan0 scan Gives me multiple ...
11
votes
3answers
19k views

Raspberry Pi 3, wifi goes to sleep?

I'm facing a similar issue to this one, How do I disable suspend mode?, except I have a Raspberry Pi 3 and am running OpenELEC 6.0.3. When I leave it on without using it for awhile, I can no longer ...
6
votes
3answers
4k views

Local network between two RPis?

I am purchasing another RPi because my original is broken, but not entirely, so I would like to chain them together via and ethernet cable. Each Pi will also have access to the internet via wifi, but ...
6
votes
2answers
11k views

Can I use eth0 and wlan0 at the same time in diffrent purpose?

I use Raspbian Jessi(kernel v4.4) on Raspberry pi 3. These are my configurations. pi@raspberrypi:~ $ cat /etc/network/interfaces source-directory /etc/network/interfaces.d auto lo iface lo inet ...
5
votes
5answers
47k views

Set static IP and stop DHCP on Jessie Lite

I've been trying for a few days now to set a static IP for my Pi but have so far been unsuccessful. I have a Model B Revision 2.0 (revision code 000d). I'm running Jessie Lite released 2016-05-27. ...
4
votes
1answer
475 views

Wireless LAN no longer works since dist-upgrade

I have been using my Raspberry Pi 1 for over a year as a wireless bridge. I purchased a Pi2 and wanted to move the SD card across, but the first thing I had to do was upgrade the distro to support the ...
3
votes
1answer
13k views

Static IP adddress on Raspbian not using dhcp service at all

I have Raspbian Jessie on RPI 2 B, I cannot set my wired NIC with a static IP address. I have uninstalled raspberrypi-net-mods ifplugd, because have a lot of stability issues and insists on uses ...
3
votes
1answer
4k views

Does appending ipv6 to /etc/modules enable IPv6 at boot?

Apparently, I can enable IPv6 in two ways. To test, I first confirm it's not enabled currently. $ ping6 -c 1 ::1 socket: Address family not supported by protocol I then enable it immediately $ sudo ...
2
votes
0answers
425 views

USB Wi-Pi not connecting to WiFi - 4-Way Handshake

I have a USB Wi-Pi stick which is supposed to enable my Pi to connect to WiFi. I have opened up 'WiFi Configuration' and when trying to connect, the status will show '4-Way Handshake' for about 10 ...
1
vote
3answers
2k views

Connect headless pi to arbitrary WiFi network

Sometimes I have to take my headless system to places that I don't know the WiFi SSID/Password before hand. SSH does not reliably work via usb, which is a pain anyways with my enclosure. Is there a ...
1
vote
0answers
64 views

How do you bridge your wlan0 to your eth0?

I'm trying to bridge the wlan interface of my Pi with the ethernet port. I found this tutorial that shows how to do this on Debian - but I'm unable to get it working. I'm quite a layman on Linux and ...
1
vote
1answer
150 views

Router not recognising Raspberry Pi 2 B

I'ver never worked with any Raspberry model before and now one of my university courses requires me to. Since I don't have any spare peripheral devices to connect the raspberry to I'm trying to access ...
0
votes
2answers
219 views

dhcp obtains IP but no connection to Internet after upgrade to Jessie from Wheezy

Device : Raspberry-Pi 2 Model B I upgraded from Wheezy 7.11 to Jessie 8.0 I upgraded using : apt-get update apt-get upgrade apt-get dist-upgrade I am connected to my eth0 (Wired LAN) when I was ...

15 30 50 per page