Linked Questions
155 questions linked to/from Raspberry Pi Power Limitations
-1
votes
1
answer
164
views
Raspberry PI Portable USB Charger [duplicate]
I bought a $5 usb charger that I am using to power my Raspberry Pi. The charger works decently but I am noticing that every once in while the raspberry pi will reboot. I have read that some chargers ...
- 75
-1
votes
1
answer
2k
views
GPIO solution to power Pi [closed]
Looking for a GPIO solution to power a Pi 3 B+. Basically, trying to bypass the Pi micro USB connector.
Also, any suggestions on hardware to build a compact, inverted, USB male right-angle ribbon ...
-1
votes
1
answer
2k
views
Raspberry Pi Low Power Warning
RPi Model B+
Raspbian 7.11
Kernel 4.14.41-v7+
I've been getting low power errors during startup (lightning bolt), and continue to see them in my syslog.
I have tried multiple different USB cables, ...
- 109
-1
votes
1
answer
144
views
Pi b+ power issues?
I have a raspberry pi b+ with raspbian stretch. My power adapter is rated at 5v 1.5 amp. I have a monitor and network cable connected, USB keyboard, USB mouse and 2 USB cameras connected via the 4 USB ...
-1
votes
1
answer
90
views
Powering External Devices
I am wanting to use a Raspberry Pi 3 to communicate with two Texas Instruments CC2538s (over serial USB), I am wondering if the RP will be able to provide enough power over its USB ports to power ...
-1
votes
1
answer
156
views
LEDS Connected to GPIO [duplicate]
How many LEDS can be connected and ON at once to the RPI GPIO without burning out the system?
- 420
-2
votes
1
answer
55
views
I want to power RP3B+ with gpio but not sure about the circuit
I got a 4 battery holder (4-Way 18650 Battery Holder from Dfrobot)
And I'm wondering do I need a resistor to power the rasbery pi via gpio 5v pin.
Or do I need something else for this power supply
The ...
- 1
3
votes
0
answers
190
views
Pi 3 - insufficient USB power available for dual-band Wi-Fi adapter?
This question says
"How much current can draw from the USB ports?
......The limit for Pi3 is 1200mA."
However, my Rosewill RNX-N600UB Wi-Fi dongle will only operate in the 5 GHz band when plugged ...
- 267
1
vote
0
answers
254
views
rPi 3b only boots with 5v power through the 3.3v GPIO
I'm in need of some explanation as my Pi is acting weird (to my limited knowledge at least)
It will only boot when i suply it with 5v/GND through the 3.3/GND GPIOs.
The pi boots when i connect 5v ...
- 203
1
vote
0
answers
160
views
Pi 3 WiFi drops
I use Raspbian Lite on my Pi 3 and have a problem where I can't access it remotely anymore - at some point. I use wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf in my /etc/network/interfaces (I ...
- 93
0
votes
0
answers
113
views
Voltage drop at 5V pin when drawing current with DC motor
I encounter a power behavior for my Raspberry Pi 4B that I struggle to explain. I try to power a (geared) DC motor using the 5V pin. DC motor is rated for 3-12V (preferred 6-8V) and is claimed to draw ...
- 1
0
votes
0
answers
43
views
My Raspberry pi keep show msg : low voltage warning please check your power supply [duplicate]
I have Raspberry pi 3 , and I am using its power supply which give 5V -2.5 A , the problem is that the raspberry Pi keep show this message : low voltage warning please check your power supply
- 11
0
votes
0
answers
65
views
Is the low voltage danger only during boot or during operation too?
I went to an authorized reseller, but they gave me this charger for my Raspberry Pi 3B. I used Etcher to write the August 2020 version of RPi OS to the SD card and it boots fine. However, during boot ...
- 101
0
votes
0
answers
367
views
Mounted USB to SSD drive locks up
I am using a Raspberry Pi 3 B+ with the official charger running Raspbian Stretch Lite (Debian Version 9.4, Kernal 4.14.34-v7+ #1110) with MariaDB (Version 10.1.23) and I am trying to import a 52GB ...
0
votes
0
answers
1k
views
Disable Power Over HDMI
I built a Retropie using a PI Model 3B that is powered via the GPIO pins. Specifically with this case which adapts micro usb to the GPIO power. Everything works fine except when I turn the system off. ...
- 101