Questions tagged [access-point]

Set the Pi as a wireless Access Point

40 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
1answer
35 views

wpa_supplicant + dnsmasq: Fallback to AP mode if no wifi connection

I'm trying to figure out how to configure wpa_supplicant to: First try to connect to a selection of preconfigured wifi networks as a DHCP client, and if that fails Set up a wifi access point using ...
2
votes
0answers
139 views

Trying to setup wifi ap and managed client mode together : sub-system time out on ap0

I followed the instructions here: enter link description here with the aim of getting ap and managed client wifi running together. The wlan0 setup works perfectly. I could not see any attempt to ...
1
vote
0answers
33 views

Android 9 phone gets wrong IP address from RPi access point

I configured my RPi (running Raspian Stretch Lite) as an access point to create a local private network (no connection to internet). Laptops and mobile phones connect fine to the AP and I can navigate ...
1
vote
4answers
100 views

Connecting Raspberry Pi Zero W to ethernet and serving as WiFi access point

I have an ethernet port in a room where I would like to improve the WiFi connection, and I have a Raspberry Pi Zero W lying around. Is there a way I can connect the Pi to the ethernet port and have ...
1
vote
1answer
93 views

Unable to use tor for all traffic directed through Raspberry Pi 3

Before all of this, I wanted to make my raspberry pi a wireless access point so that all traffic is anonymous through tor. I currently have Raspberry pi 3 b+ and I installed Raspbian freshly. Pi 3 B+ ...
1
vote
1answer
105 views

My Access Point isn't working, could I get some help?

I went through a tutorial on thepi.io. However, my AP isn't showing up or not working. I ran the: sudo hostapd /etc/hostapd/hostapd.conf then it came back as: failed to create interface ...
1
vote
2answers
217 views

I can't get WiFi access point (AP) working on my RPi

I want to control my Raspberry Pi 3B+ using VNC via the on-board WiFi. To this end, I am trying to set up a WiFi access point on wlan0. I followed the instructions at https://www.raspberrypi.org/...
1
vote
0answers
152 views

Run Raspberry Pi 3 as VPN access point with pi-hole

I've got my Raspberry Pi with Raspbian running as pi-hole, connected through Wi-Fi to OpenVPN with most of my devices, where it blocks ads. I'd like to set RPI as VPN access point without ...
1
vote
0answers
27 views

can not ping from remote host over raspberry pi router

Going through Setting up a Raspberry Pi as an access point in a standalone network (NAT) I set up Raspberry pi as access point as standalone NAT with out bridging. wireless host is connected but cant ...
1
vote
1answer
421 views

Pi Zero W Wifi repeater with OpenVPN

Im trying to setup a Pi Zero W as a wifi repeater with openVPN without using a USB wifi dongle, as a tiny travel router. I tried using this tutorial - by @ingo raspberry-pi-zero-w-as-a-wifi-repeater ...
1
vote
0answers
46 views

hostapd - using Pi 3 as access point while maintaining Ethernet connection (no bridge)

Currently I have my Pi setup as an access point; It creates its' own network with an SSID and my other devices can connect and exchange messages. For this, I use hostapd and dnsmasq thru wlan0. ...
1
vote
1answer
200 views

OVS + Hostapd Raspberry pi setup

My experimental aim is to create OVS+Hostapd on raspberrypi 3B Module connected to PC as sdn controller. initial ovs configuration is ovs-vsctl add-br0 br0 ovs-vsctl add-port br0 eth0 Setting up ...
1
vote
0answers
261 views

Captive Portal using systemd raspbian stretch

I am trying to setup a captive portal on my raspbian stretch access point connecting to my node server. Currently using systemd to set up my network so I can ssh into my pi and use it as a access ...
1
vote
1answer
821 views

Raspberry Pi Access Point name instead of IP

I've created an access point on my Pi, and created a website. I can connect my pi with an ethernet cable to my laptop (with shared internet) so that the Pi goes into a subnet, and can connect to ...
1
vote
2answers
5k views

raspberry pi as access point with captive portal

I recently got a raspberry pi. I have it set up as an access point in a standalone network (not connected to the internet). I can also serve a static website on this network. Ive been trying to set up ...
0
votes
0answers
30 views

setting up multiple IP addresses on one ethernet interface?

I am running Buster on a RP3B+. It is configured as a stand-alone wifi access point running dnsmasq. No bridging to the eth0 / Internet. It also has a wired eth0 interface. Everything is working ...
0
votes
0answers
28 views

Access Point consumption

I'm using my Raspberry Pi as an access point and I was wondering : how does it work ? What is the protocol for an access point to be visible from other devices ? How much data they have to transmit ...
0
votes
0answers
18 views

How to connect wifi wlan1 and share it by wlan0

How to connect wifi wlan1 and share it by wlan0 I would like to use raspberry pi become hostpot wifi. connect wifi by wireless and share it not use ethernet or lan.
0
votes
0answers
30 views

Using Pi as an intermediary between 2 LANs

I have one raspberry pi which is running Hassio (Home automation stuff). Normally I would just connect the devices I wanted to automate to home LAN but the problem is my wifi SSID & Password might ...
0
votes
0answers
45 views

Raspberry Pi 3 Access Point - No Client IP

I followed the official Raspberry Pi documentation for "Setting up a Raspberry Pi as an access point in a standalone network (NAT)", but I can't get an IP address on the client. When I assign a static ...
0
votes
1answer
24 views

ELI5 how to use my pi3 model b as access point?

I have no clue about networking in general so need a little help. Here's my problem (very First World): I want to be able to use my house wifi whilst sitting in my garden but the signal is really too ...
0
votes
0answers
29 views

pureVPN router on pi3 B+ Noobs

I've been trying to setup my pi 3 B+ to be a VPN router, im using pureVPN as the service and have a combination of pureVPN's guidelines and the following two setup guides first the wireless access ...
0
votes
0answers
42 views

Setting up an SSL certificate on a web-server hosted by a Raspberry Pi?

I'm developing a bat detector and I've set up the Raspberry Pi to operate its own Apache Web server on its own access point. The idea is that client devices can then connect to the access point to ...
0
votes
0answers
33 views

How to redirect domain to test server IP using bridged wlan0 to eth0 connection?

Following this tutorial https://www.raspberrypi.org/documentation/configuration/wireless/access-point.md from "Using the Raspberry Pi as an access point to share an internet connection (bridge)" ...
0
votes
0answers
161 views

Create Access Point in Latest Raspbian OS using Edimax EW-7811Un for compute module 3

I am trying to create an access point in compute module 3(and latest Raspbian OS) with the Edimax WiFi dongle. But it did not succeed to create. Anyone please help me to do that in the latest ...
0
votes
1answer
193 views

Raspberry 3B+ Wi-Fi in access point mode

I have installed the latest Raspbian Light on my new Raspberry 3B+ then followed the tutorial here: https://www.raspberrypi.org/documentation/configuration/wireless/access-point.md My system is: $...
0
votes
0answers
218 views

hostapd acces point configuration file

I'm using this to turn my raspberry pi into an access point https://github.com/Phoenix1747/RouteryPi This is my hostapd.conf file: # Bridge mode bridge=br0 # Networking interface interface=wlan0 # ...
0
votes
0answers
34 views

Hostapd interworking http redirection not working on RPI access point

I am trying to redirect a client on node web server once connected to the RPI accesspoint. I am using hostapd as the access point on my RPI stretch. My goal is for a client's browser to open to my ...
0
votes
0answers
13 views

RPI access point and how to share the internet with connected devices

I want to share the Internet from my USB modem stick on my raspberry pi to other devices by turning my pi into a WiFi access point. I am using a pi 3 model B+ running raspbian stretch and I am able to ...
0
votes
1answer
519 views

Access point as a Wifi repeater for WPA2-Enterprise network

So this is a little bit of a random question but I'm attempting to follow this tutorial to set up a wifi repeater with my Raspberry Pi 3B+. I can get the Raspberry Pi to generate a network that can ...
0
votes
1answer
186 views

switch raspberry pi from client mode to access point mode without rebooting

i use this https://www.raspberrypi.org/documentation/configuration/wireless/access-point.md tutorial to turn raspberry pi3 to an access point and also i write a script to hide the ssid and another ...
0
votes
0answers
30 views

Socket Over Non-Internet Access Point

I want to use a Raspberry Pi as an access point that is not linked to the internet. If I connected one other device to that access point, how could I connect a socket between this access point and the ...
0
votes
1answer
361 views

Make wifi onboard as an access point and wifi dongle as a client

I want to turn my raspberry pi 3 witch installed Raspbian OS to access point and client to access wifi and bridge these two each other (in this question it's better to skip this bridge part). Exactly, ...
0
votes
1answer
251 views

Connect Android and Pi 3 via network socket using Pi 3 as an access point

Cross post with https://stackoverflow.com/questions/52596484/connect-android-and-pi-3-via-network-socket-using-pi-3-as-an-access-point, please delete if this isn't allowed. My plan here is to create ...
0
votes
1answer
266 views

Switch Raspberry Pi 3 between access point and non-access point

I used this tutorial to make my Raspberry 3 an access point. After following that, I can't connect to the internet—neither via Wi-Fi nor via cable. With this tutorial when I see the DHCP status—it ...
0
votes
0answers
213 views

RPi3 captive portal iptables issues

I've been spending the last week or so learning how to program the Rpi3, and have so far had success. This is where I'm stuck at. I've set up an access point (here: https://www.raspberrypi.org/...
0
votes
2answers
649 views

Raspberry Pi 3 access point stops working

I set up a Raspberry Pi 3 as an access point following the documentation for connect a smartphone on tornado websocket on python It works but frequently the AP stops working and I have to restart ...
0
votes
0answers
182 views

WAP Raspberry Pi 3 B+ unstable

I've configured my Raspberry Pi 3B+ as a WAP by using its built in wireless network interface. The WAP shows up as a WiFi network on my Ubuntu 16.04 laptop. I can connect with the credentials and I ...
0
votes
2answers
157 views

Clarification on Access point as WiFi repeater, optional with bridge needed

Regarding the detailed instructions for Access point as WiFi repeater, optional with bridge here: Access point as WiFi repeater, optional with bridge Since the raspberry pi 3 b+ has only one radio, ...
-1
votes
1answer
53 views

Hostapd and dnsmasq are set up but i dont get any signal on my devices

i have set up hostapd and dnsmasq and ran into some issues. at first the issue was that hostapd didn't recognized the driver. after i deleted that line it did start up. then dnsmasq told me that there ...