Questions tagged [dc-motor]

DC motors are commonly used in robotics and vehicles. They come in brushed and brushless versions; the latter also includes stepper motors. Note they are distinct from servos, for which there is a separate tag.

Filter by
Sorted by
Tagged with
1
vote
1answer
305 views

Why isn’t my Raspberry Pi motor spinning?

I have used the raspberry pi for almost 5 months now, so I could say I am new. Everything was fine at the start but when I built a car my motors will not spin. I am using DC motors (approximately 9V)...
0
votes
1answer
118 views

Why don't my motors rotate?

I know I asked this question before, but this time I will give a more clearer description. I have been using the raspberry pi for approximately 6 months now. I am making a very simple robot car that ...
-1
votes
1answer
97 views

Sg 5010 servo 360 degree modification not working [closed]

As per the video tutorials out there, I opened the motor, took out the potentiometer and measured its resistance at max. Its a b5k pot so it measured 5kohm I put 2.5k ohm from each pin (s and -) and ...
4
votes
3answers
2k views

rPi2 model B v1.1 smoke comes out near power port

I am trying to control 2 motors using the E-gizmo Motor driver shield but suddenly smoke comes out near the power port of the raspberry pi 2 so I immediately unplugged the power supply. After that, I ...
1
vote
1answer
176 views

Rpi GPIOzero L298N DC Motor Driver Problem

I built a buggy: https://projects.raspberrypi.org/en/projects/build-a-buggy/2 it seems like it works correctly, except the motor doesn't stop even when I run robby.stop() is there some other command ...
2
votes
1answer
139 views

Controlling 28byj48 bipolar convert with l293d ic

So I'm having issues with controlling the motor with this ic. I have got it to work when it was unipolar with the uln2003. I slit the red wire so there are only 4,two windings. Measured ohms across ...
2
votes
1answer
135 views

part incompatibilities

I am trying to control a 4.5V motor with a pi. I am going to use this to control the motor: https://www.ebay.com/itm/2X-L298N-Dual-H-Bridge-DC-Stepper-Motor-Driver-Controller-Board-Arduino/...